User Manual

12
Example: To Use the Spreader Wedge
1. Determine which direction part needs to be bent.
2. Remove any obstructions that could be damaged or are in the way.
3. Place Spreader Wedge so that the hinged arm is resting against the part to be moved and the
stationary arm is resting against a non-movable base. Hold the Spreader Ram in position and apply
the Pump Unit pressure. Once contact on either end has been made, step away as far as possible
and continued to slowly apply pressure to the damaged area until the desired bend has been made.
4. When the damaged area has been bent to the desired position, slowly turn the Release Valve Stem
on the Pump Unit in a counterclockwise direction to release the hydraulic pressure and remove the
Hydraulic Ram.