User Manual

13
MAINTENANCE INSTRUCTIONS
If you use and maintain your equipment properly, it will give you many years of service. Follow the
maintenance instructions carefully to keep your equipment in good working condition. Never perform any
maintenance on the equipment while it is under a load.
Inspection
You should inspect the product for damage, wear, broken or missing parts (e.g.: pins) and that all
components function before each use. Follow lubrication and storage instructions for optimum product
performance.
Binding
If the product binds while under a load, use equipment with equal or a larger load capacity to lower the load
safely to the ground. After un-binding; clean, lubricate and test that equipment is working properly. Rusty
components, dirt, or worn parts can be causes of binding Clean and lubricate the equipment as indicated in
the lubrication section. Test the equipment by lifting without a load. If the binding continues, contact Customer
Service.
Cleaning
If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean
the equipment. Remove any existing rust, with a penetrating lubricant.
Lubrication
This equipment will not operate safely without proper lubrication. Using the equipment without proper
lubrication will result in poor performance and damage to the equipment. Some parts in this equipment are
not self-lubricating inspect the equipment before use and lubricate when necessary. After cleaning, lubricate
the equipment using light penetrating oil or lubricating spray.
-Use a good lubricant on all moving parts.
-For light duty use, lubrication is needed once a month.
-For heavy and constant use, lubrication is recommended every week.
-NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE SURFACES!
Rust Prevention:
-Check rams and pump plungers on the power unit assemblies daily for any signs of rust or corrosion.
Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of
rust are visible clean as needed.
How the Equipment Operates
With release valve closed, an upward stroke of the handle draws oil from the reservoir tank into the plunger
cavity. Hydraulic pressure holds the valve closed, which keeps the oil in the plunger cavity. A downward
stroke of the handle releases oil into the cylinder, which forces the ram out. This raises the saddle. When the
ram reaches maximum extension, oil is bypassed back into the reservoir to prevent an over extended ram
stroke and possible damage to the unit. Opening the release valve allows oil to flow back into reservoir. This
releases hydraulic pressure on the ram, which results in lowering the ram.
Storing the Product
1. Lower to the lowest resting position.
2. Place the handle in the resting position.
3. Store in a dry location, recommended indoors.
Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the
equipment stays in good working condition.