User Manual

TO ADD OIL TO HYDRAULIC PUMP UNIT:
After extensive use, the hydraulic oil supply
should be replaced to ensure longer equipment
life.
1. Set Pump Unit upright on a level surface.
2. Remove the Screw with its attached dipstick.
3. Add 0.24 Qts (approximately 7.68oz./ 220ml)
of oil. The oil level should be near position A.
Use a high grade anti-foaming hydraulic oil.
KEEP DIRT AND OTHER MATERIALS
CLEAR WHEN POURING.
4. Replace the Oil Fill Screw.
5. Perform the Air Purge Procedure.
TO REPLACE OIL TO HYDRAULIC PUMP UNIT :
1. Set Pump Unit flat on a level surface.
Remove the screw with its attached dipstick.
2. Turn the Pump Unit on its side so that old oil
will drain from the oil fill hole.
3. Set Pump Unit upright on a level surface.
4. Add (0.24 Qts / 220ML) of oil. The oil level
should be near position A.
Use a high grade anti-foaming hydraulic oil.
KEEP DIRT AND OTHER MATERIALS
CLEAR WHEN POURING.
6. Replace the Oil Fill Screw.
7. Perform the Air Purge Procedure.