User Manual

IMPORTANT SAFETY CONSIDERATIONS

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFETY INSTRUCTIONS AND

WARNING. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE OF WHICH IT

IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE TO PROPERTY AND/OR SERIOUS

PERSONAL INJURY. PLEASE KEEP THIS INSTRUCTION MANUAL SAFE FOR FUTURE USE.

We’ve done all we can to assure this equipment offers the outmost in safety, but you have to do your part.

No amount of warning can take the place of your good judgment, so make sure it’s the first thing you

bring to any job. Beyond that here are some obvious tips:

 Steel and other materials can shatter, so always use ANSI approved impact safety goggles, full-face

impact safety shield and heavy-duty work gloves when operating.

 Remove loose fitting clothing. Remove ties, watches, rings and other loose jewelry and contain long

hair.

 Keep proper balance and footing, do not over-reach and wear nonskid footwear.

 Do not operate the when you are tired or under the influence of alcohol, drugs or an intoxicating

medication.

 Keep hands and feet away from work area at all times.

 Do not allow untrained persons to operate the equipment.

 If you detect anything that may indicate imminent structural failure, stop using the product

immediately and inspect it thoroughly.

 Do not use to compress springs or any other item that could disengage and cause a potential flying

hazard.

 Use this equipment for the purpose for which it is intended. Do not use it for any other purpose it is

not designed to perform.

 Keep children and unauthorized persons away from the work area.

 Only use this equipment on a surface that is stable, level, dry and not slippery, and capable of

sustaining the load. Keep the surface clean, tidy and free form unrelated materials and ensure that

there is adequate lighting.

 Inspect before each use. Do not use if bent, broke, cracked, leaking or otherwise damaged.

 Use extreme caution when working around any parts that are subjected to a shock load.

 Check to ensure that all applicable bolts and nuts are firmly tightened.

 Ensure that work piece is center-loaded and secure.

 Do not make any modifications to the equipment.

 Do not use brake fluid or any other improper fluid and avoid mixing different types of oil when adding

hydraulic oil. Only good quality hydraulic jack oil can be used in equipment.

 Do not expose the equipment to rain or any other kind of bad weather.

 If the equipment needs repairing and/or there are any parts that need to be replaced, have it

repaired by authorized technicians and only use the replacement parts supplied by the

manufacturer.