User Manual

7
SADDLE
1. Mount the four angle brackets (T4) to the saddle
using screws (T5), washers (T6), spring washers
(T7) and nuts (T8). Attach the hook guide (13)
to the saddle with washer (5), spring washer (6)
and nut (7) and assemble the chain hook-to-hook
guide (13) with two screws (4) and washers (3).
And then tighten screw (17) through the chain to
the saddle with washers (18), spring washers (3)
and nuts (4).
SYSTEM AIR PURGE PROCEDURE
IMPORTANT: BEFORE FIRST USE
Perform the following Air Purge Procedure to remove any air that may have been introduced into the hydraulic
system as a result of product shipment and handling. This step is to be completed without any weight on the
jack.
20
T4
7
6
5
13
T6
T5
4
3
18
3
4
T8
17
T7
T6
2. Pump handle (21) eight full strokes.
1. Turn release valve (R25) counterclockwise one
full turn to the open position.
3. Turn release valve (R25) clockwise to the closed
position.
R25
21
21
R25
4. Pump handle (21) until the ram reaches about half
height; continue to pump several times to remove
trapped air in the ram.
ASSEMBLY