User's Manual

ManualsBrandsBigben Interactive ManualsElectronicsHandle bar unit for cyberbike

SUOMI DANSK NORSK SVENSKA PORTUGUÊS ITALIANO ESPAGÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

2.a. Assembling the parts

FRONT BACK

Fig.1

Front and rear supports: Turn

the Cyberbike™ upside down

and attach the feet as shown

in  g1. Position the screws and

tighten using the assembly tool

provided. (Fig.1)

Fig.2

Seat: Firstly connect the cable from the seat post to the

cable in the main body of the Cyberbike. Ensure the

connectors clip together.

Then insert the tube supporting the seat into the Cyberbike™

main frame.( g.2)

Fig.3

Handlebar: Connect the cable inside the

tube before inserting the handle bar tube

into the Cyberbike™ base.

Insert the handlebar tube into the

Cyberbike™ main frame as shown.

Insert the 4 short bolts into the holes

provided and tighten with the assembly

tool to make sure the handlebar is secure.

(  g . 3 )

Fig.4

To  t the supplied remote control holder,

simply slide it onto the holding bracket on

front of the handlebar support . ( g.4)

Fig.5

Pedals: Each pedal is marked as left and

right. It is essential that you insert the

correct pedal to each side. Tighten the

pedals with the tool provided. ( g.5).

Fig.6

Ensuring bike stability

Should your bike wobble during use,

rotate one of the plastic end caps on either

the front or back support until it becomes

perfectly stable. ( g.6)

Battery installation: Insert the batteries

supplied, into the battery compartment

on the rear of the control area. Make sure

you insert them in the correct positions,

observing the + and – connections.

2.b. Connecting the Cyberbike™

For initial connection, switch on your TV and the Cyberbike. The Cyberbike will now pair

with the receiver. When paired, the LEDs on the Cyberbike and the receiver will remain

fully lit.