User's Guide
Table Of Contents
- 1 Tips for Reading and Understanding this User Guide
- 2 Before you Begin Using Bigfoot Unity
- 3 Indications and Safety Information
- 4 Bigfoot Unity Welcome Kit
- 5 First Time Setup of Bigfoot Unity
- 6 Using Bigfoot Unity Caps
- 6.1 Pairing the Black and White Caps
- 6.2 Using the Black and White Caps
- Viewing Time Since Last Long-Acting Dose on the Black Cap
- Viewing Long-Acting Dose Amount on the Black Cap
- Viewing Time Since Last Rapid-Acting Dose on the White Cap
- Using your White Cap to View Current Glucose
- Viewing Correction Dose Amount on the White Cap
- Viewing Meal Dose Amounts on the White Cap
- Viewing Meal + Correction Dose Amounts on the White Cap
- 6.3 Using your Caps when Replacing Insulin Pens
- 6.4 Making Diabetes Treatment Decisions
- 6.5 Charging your Caps
- 7 Using the Sensor
- 8 Daily Use and Additional Features
- 9 Care, Maintenance and Disposal of Bigfoot Unity
- 10 Troubleshooting
- Appendix A: Receiving and Responding to Notifications/Alerts on your App/phone
- Appendix B: Settings for Bigfoot Unity App
- Appendix C: Technical Information
- C.1 Labeling Symbols
- C.2 Sensor Specifications
- C.3 Cap Specifications
- C.4 Communications Specifications
- C.5 Bigfoot Unity™ Diabetes Management System Specifications
- C.6 Kit Specifications
- C.7 Security Measures
- C.8 Quality of Service (QoS)
- C.9 Meter Specifications
- C.10 Performance Characteristics of the FreeStyle Libre 2 Flash Glucose Monitoring System*
- C.11 Electromagnetic compatibility (EMC)
- C.12 Warranty
- Index
117
The Bigfoot Unity
™
Diabetes Management System User Guide | Chapter 8
CAUTION: Make sure your phone is within communication
range (within 20 ft) of your Caps after you make any changes to your
insulin settings within the App. If your Caps do not have the most
current settings, you could take too much or too little insulin, which
may result in severe low or high glucose.
• If your Cap is unable to communicate with the App, if you tap
< Back to go back to the Home screen, or if you tap I don’t
have my Cap right now (tap OK on next screen) insulin
updates will be saved and sent at a later time. Under MY
SETTINGS (and under Insulin Settings) there will be an “Update
Pending” note.
• If you try to edit and save insulin
settings but have previously pending
updates to your long-acting or rapid-
acting insulin, Mealtime Insulin or
Correction Insulin, you will rst be
prompted if you want to replace those
pending updates with the changes just made. Tap Replace to
replace pending updates with your new updates and continue,
or tap Cancel to review and accept the pending update. See the
Accepting pending insulin updates section that follows for more
information on pending updates.
1. Follow the instructions on the App screens for sending rapid-acting
insulin updates to your White Cap and wait for the conrmation
screen and check mark ( ) to appear. Follow the same steps for
sending long-acting insulin updates to your Black Cap.