User's Guide
Table Of Contents
- 1 Tips for Reading and Understanding this User Guide
- 2 Before you Begin Using Bigfoot Unity
- 3 Indications and Safety Information
- 4 Bigfoot Unity Welcome Kit
- 5 First Time Setup of Bigfoot Unity
- 6 Using Bigfoot Unity Caps
- 6.1 Pairing the Black and White Caps
- 6.2 Using the Black and White Caps
- Viewing Time Since Last Long-Acting Dose on the Black Cap
- Viewing Long-Acting Dose Amount on the Black Cap
- Viewing Time Since Last Rapid-Acting Dose on the White Cap
- Using your White Cap to View Current Glucose
- Viewing Correction Dose Amount on the White Cap
- Viewing Meal Dose Amounts on the White Cap
- Viewing Meal + Correction Dose Amounts on the White Cap
- 6.3 Using your Caps when Replacing Insulin Pens
- 6.4 Making Diabetes Treatment Decisions
- 6.5 Charging your Caps
- 7 Using the Sensor
- 8 Daily Use and Additional Features
- 9 Care, Maintenance and Disposal of Bigfoot Unity
- 10 Troubleshooting
- Appendix A: Receiving and Responding to Notifications/Alerts on your App/phone
- Appendix B: Settings for Bigfoot Unity App
- Appendix C: Technical Information
- C.1 Labeling Symbols
- C.2 Sensor Specifications
- C.3 Cap Specifications
- C.4 Communications Specifications
- C.5 Bigfoot Unity™ Diabetes Management System Specifications
- C.6 Kit Specifications
- C.7 Security Measures
- C.8 Quality of Service (QoS)
- C.9 Meter Specifications
- C.10 Performance Characteristics of the FreeStyle Libre 2 Flash Glucose Monitoring System*
- C.11 Electromagnetic compatibility (EMC)
- C.12 Warranty
- Index
180
The Bigfoot Unity
™
Diabetes Management System User Guide | Appendix C
C.11 Electromagnetic Compatibility (EMC)
Bigfoot Unity has been tested and found to be appropriate for use
at home. In most cases, Bigfoot Unity should not interfere with other
home electronic devices if used as instructed. However, the Caps,
Sensor, Meter, and your phone give off radio frequency (RF) energy.
The low level of RF energy emitted by the system is not likely to cause
interference in nearby electronic equipment. However, if not used
correctly, these Bigfoot Unity devices may interfere with your TV, radio,
or other electronic devices that receive RF signals.
In addition, except for your Bigfoot Unity-related devices, other
electronic wireless devices that are in use nearby, such as another cell
phone or a wireless network, may prevent or delay the transmission
of data between the different devices that make up the Bigfoot Unity
System. If you nd that glucose values are not sent to your White Cap
from the Meter, or if Sensor or Cap data is not being sent to the App,
it may be due to electromagnetic interference. To avoid interference,
you may be able to move to a different location to Use Bigfoot Unity.
Alternatively, you could turn off other nearby electronic devices or
antennas to avoid interference. Similarly, if you nd that the White Cap
will not scan the Sensor, try moving to another location.
If you experience problems receiving data on your Cap or App after
moving Bigfoot Unity away from any potential source of interference,
contact Bigfoot Customer Care at (551) 244-3668.
Special precautions must be taken to avoid increased emissions of RF
or decreased immunity to RF, including:
• Installing and using Bigfoot Unity in accordance with the instructions
provided in this User Guide.
• Using only accessories, transducers, and cables specied by
Bigfoot Biomedical.
• Avoiding using Bigfoot Unity adjacent to other electrical equipment,
or if adjacent use is necessary, Bigfoot Unity should be observed to
verify normal system operation.
• Not making any modications to Bigfoot Unity components that are
not approved by Bigfoot Biomedical.