User's Guide
Table Of Contents
- 1 Tips for Reading and Understanding this User Guide
- 2 Before you Begin Using Bigfoot Unity
- 3 Indications and Safety Information
- 4 Bigfoot Unity Welcome Kit
- 5 First Time Setup of Bigfoot Unity
- 6 Using Bigfoot Unity Caps
- 6.1 Pairing the Black and White Caps
- 6.2 Using the Black and White Caps
- Viewing Time Since Last Long-Acting Dose on the Black Cap
- Viewing Long-Acting Dose Amount on the Black Cap
- Viewing Time Since Last Rapid-Acting Dose on the White Cap
- Using your White Cap to View Current Glucose
- Viewing Correction Dose Amount on the White Cap
- Viewing Meal Dose Amounts on the White Cap
- Viewing Meal + Correction Dose Amounts on the White Cap
- 6.3 Using your Caps when Replacing Insulin Pens
- 6.4 Making Diabetes Treatment Decisions
- 6.5 Charging your Caps
- 7 Using the Sensor
- 8 Daily Use and Additional Features
- 9 Care, Maintenance and Disposal of Bigfoot Unity
- 10 Troubleshooting
- Appendix A: Receiving and Responding to Notifications/Alerts on your App/phone
- Appendix B: Settings for Bigfoot Unity App
- Appendix C: Technical Information
- C.1 Labeling Symbols
- C.2 Sensor Specifications
- C.3 Cap Specifications
- C.4 Communications Specifications
- C.5 Bigfoot Unity™ Diabetes Management System Specifications
- C.6 Kit Specifications
- C.7 Security Measures
- C.8 Quality of Service (QoS)
- C.9 Meter Specifications
- C.10 Performance Characteristics of the FreeStyle Libre 2 Flash Glucose Monitoring System*
- C.11 Electromagnetic compatibility (EMC)
- C.12 Warranty
- Index
94
The Bigfoot Unity
™
Diabetes Management System User Guide | Chapter 7
4. Line up the dark mark on the Sensor
Applicator with the dark mark on the
Sensor Pack. On a hard surface, press
rmly down on the Sensor Applicator until it
comes to a stop.
5.
Lift the Sensor Applicator out of the Sensor
Pack.
6.
The Sensor Applicator is prepared and
ready to Apply the Sensor.
CAUTION: The Sensor Applicator
now contains a needle. Do NOT touch
inside the Sensor Applicator or put it
back into the Sensor Pack.
7. Place the Sensor Applicator over the
prepared site and push down rmly
to apply the Sensor to your body.
CAUTION: Do NOT push down on
the Sensor Applicator until placed over
prepared site to prevent unintended
results or injury.
8. Gently pull the Sensor Applicator away
from your body. The Sensor should now be
attached to your skin.
Note: Applying the Sensor may cause
bruising or bleeding. If there is bleeding
that does not stop, remove the Sensor and
contact your health care provider.