Use and Care Manual

Aenon
 When removing shipping feet, start on one side and then move to the
other. Only remove one shipping foot at a me.
 If your safe is under 500 lbs, use a minimum of 2 people. If your safe is
over 500 lbs, professional installaon is highly recommended.
1. Make sure door is closed and handle is
spun counter-clockwise to keep safe
door closed.
2. On a Bighorn or Kodiak, you will need
either a 17mm or a 19mm socket
wrench to remove the shipping feet.
(Wrench not included)
3. Place wrench on head of bolt. Begin
turning bolt counter-clockwise to re-
move. Repeat for both bolts.
4. Angle the safe to the le (or right for
le side shipping foot) slightly, as
shown, and carefully pull shipping feet
away from boom of safe.
5. Once the shipping foot has been re-
moved from one side of the safe, care-
fully lower safe to the oor.
Proceed removing bolts from other side
of the safe, and follow steps 4 and 5.
Have an assistant brace the safe.
Use a minimum of two people for this
step.
3
Removing Shipping Feet
On Your Bighorn or Kodiak Safe
12
Operang The Lock
 Enter the exisng six digit code. The lock comes from the factory set to
1-2-3-4-5-6. Each key press is conrmed with an audio and visual (LED
ash) signal.
 The lock will indicate a valid code entry with a double signal.
 Within 6 seconds, turn the ring around the keypad clockwise unl it
stops. Then turn the handle on your safe clockwise and pull the door
open.
 To lock the safe, turn the handle on your safe counter-clockwise unl it
stops. Then turn the ring around the keypad counter-clockwise. The lock
will beep twice when it has re-engaged.
Wrong Try Penalty
 Every invalid code entry is indicated by a triple signal. Entering 5
consecuve invalid codes starts a 3 minute delay period. (LED will ash at
5 or 10 second intervals.)
 During the delay period, pressing any key will extend the delay period a
few seconds.
Changing Your Code
Before changing your code, open the door and extend the door bolts. Always
leave the door open when changing your combinaon.
 Press “0” (zero) six mes.
 Enter your exisng six digit code once.
 Enter the NEW six digit code twice.
 Enter the NEW code one more me to unlock the safe.
If a mistake is made, wait ten seconds and repeat steps 1-4.
-Always test the lock several mes with the door sll open.
-If you just changed your combinaon for the rst me, always check to make
sure that 1-2-3-4-5-6 (factory default) will no longer open the lock.
-When creang new combinaons, avoid using personal data such as birth
dates, street numbers or phone numbers to keep your valuables as secure as
possible.
Always keep a copy of your combinaon in a secure locaon
outside of your safe.