User Manual

1 — SAFETY
7
MAINTENANCE SAFETY
Ensure the following general safety precautions are
followed while performing maintenance on the
articulating boom lift:
General Maintenance
ALWAYS perform maintenance procedures
according to manufacturer’s guidelines. NEVER
disregard or bypass proper maintenance
procedures.
ALWAYS inspect hydraulic system to ensure that all
lines, connectors and fittings are properly fastened
and in good condition.
ALWAYS turn the key switch OFF and remove key
before performing maintenance.
ALWAYS perform maintenance with the boom and
platform in a fully lowered, stowed position, when
possible. ALWAYS secure the boom before
performing maintenance on hydraulic cylinders.
ALWAYS disconnect power to the hydraulic pump
drive motor before making electrical checks to the
hydraulic valves.
ALWAYS keep all mechanical parts properly
adjusted and lubricated according to maintenance
schedule and manufacturer’s specifications.
ALWAYS perform a function check of operating
controls before each use and after repairs have
been made.
ALWAYS locate and protect against possible pinch
points before performing any maintenance or
repairs.
ALWAYS use only manufacturer-approved parts to
repair or maintain equipment. If any portion of this
equipment is rebuilt or repaired, retesting is required
in accordance with factory instructions.
ALWAYS maintain a safe distance while testing the
hydraulic components. ALWAYS relieve hydraulic
pressure before loosening or removing hydraulic
components. NEVER test or operate the hydraulic
components while personnel are near the
equipment.
NEVER allow water or foreign particles into the DC
electric motor housing. Inclusion of water or foreign
particles may cause serious damage to the motor. If
the motor becomes wet, consult an authorized Bil-
Jax service technician for proper drying instructions.
NEVER add unauthorized fluids to the hydraulic
system or battery. NEVER mix hydraulic oils.
Consult manufacturer specifications. Refer to
Section 4 for hydraulic system maintenance
procedures.
NEVER exceed the manufacturer’s recommended
relief valve settings.
NEVER touch or allow metal tools to contact any
components that are sensitive to static discharge.
ALWAYS use static discharge prevention mats and
grounding devices when handling electronic
components.
NEVER adjust, repair, replace or bypass any
hydraulic or electrical control or safety device. These
include, but are not limited to, hydraulic load control
and flow control valves, solenoid valves and limit
switches. ALWAYS consult an authorized Bil-Jax
technician if repairs are necessary.
NEVER modify, alter or change the equipment
without first consulting an authorized Bil-Jax
technician, and NEVER in any way that would affect
its original design or operation.
Battery Maintenance
Ensure the following general safety precautions are
followed when performing battery maintenance on
the Aerial Work Platform.
ALWAYS wear safety glasses when working with or
near batteries.
ALWAYS check the battery fluid level daily.
ALWAYS avoid contact with battery acid. Battery
acid causes serious burns and should be kept away
from skin or eyes. If contact occurs, flush with water
and consult a physician immediately.
ALWAYS disconnect ground cable first when
removing battery.
ALWAYS connect ground cable last when installing
battery.
ALWAYS charge batteries in open, well-ventilated
areas.
ALWAYS replace batteries using only parts
recommended by manufacturer. ALWAYS use only
batteries with sealed caps over cells.
NEVER smoke while servicing batteries.
NEVER charge batteries near spark or open flame.
NEVER allow batteries to overcharge and boil.
NEVER short across battery posts to check for
current. NEVER break a live circuit at the battery.
NEVER disconnect battery from charger while
charger is connected to a live power source.
NEVER jumpstart other vehicles using the boom lift
batteries.