Installation Guide

Attachment Instructions

for

SCAPEWEL

Cover Clips

Six (6) metal clips with 1/2” screws are provided. Indents

are molded into the outside top of each side panel for clip

attachment. Attach Clips as follows:

Using a 3/32” size drill bit, pre-drill a hole at each

indent location. Position the clip in the indent as shown

to mark the hole location.

Attach clips as shown.

“SNAP” the clips ends over the lip of the Cover.

For additional information or questions,

please contact The Bilco Company at:

1-800-854-9724 or www.bilco.com

For Emergency Egress: Place both hands in the center of cover and push up and away

from the house. Make sure everyone in the household understands how the cover is removed.

Screw

Metal Clip

Side

Panel

WWLBL001 REV: 2

Building on Our Tradition