User Manual

User guide
Billi B-1000.
Billi Filter Cartridges
The B-1000 features the Billi dual stage
filtration system. It is fitted with single
dual stage filter incorporating sediment and
chemical removal elements. All B-1000 filters
are manufactured using bacteria and biofilm
resistant materials for improved water quality.
Premium filters provide a better tasting water
due to the high quality, carbon chemical
removal filter. Sub-micron rated, these
filters have excellent chemical absorption,
removing or reducing chlorine, volatile organic
compounds (VOCs), chemicals, tastes and
odours. All drinking water filtration systems
should be flushed after a period
of non-use.
There are 2 types of filter cartridge sets
oered.
994001 5.0 micron replacement filter
994002 0.2 micron replacement filter
Use only genuine Billi Filter Cartridges as
designed for this system.
If the system has not been used for a period
of 3 days or more, lift the dispenser lever and
flush the system for at least 1 minute.
Filter Cartridges Service Interval
Periodic replacement of your Billi B-1000
filter cartridge is necessary to maintain the
sparkling freshness of your drinking water.
Your Billi Representative will advise you of
an appropriate service interval. As a guide,
the filters should be serviced twice yearly.
In areas where water supply has a high level
of sediment, more frequent replacement of
filter cartridges may be necessary. This will
become evident when a significant drop in
delivery flow rate occurs.
4
Filter Cartridge Replacement
When you receive your replacement
cartridges, follow the procedure as
outlined below:
1. Turn o water supply to unit.
2. Remove front panel to unit.
3. Turn temperature control to OFF
4. Open tap to release any pressure.
5. Close tap.
6. Grasp the bottom of the filter and pull
towards yourself slowly. The top of the
filter is in a hinged cradle assembly.
It should stop after approximately
30 degrees of travel.
7. The filter can now be released from the
holding cradle by pulling down on the filter.
8. Take care not to spill water in the base
of the tray. If so wipe gently with blotting
paper.
9. Install new filter into the same location
by pushing up into the cradle all the way.
10. Push filter forward until upright and
locked in place.
11. Turn water supply to unit on.
12. Open tap again.
13. Run water for 2-3 minutes to flush all
air out and condition the filter.
14. Close tap.
15. Check for any leaks from around the filter,
hosing or pipe work.
16. Turn temp control to ON & set temperature
to desired level.
17. Close front cover.