Installation guide Billi B-3000
Installation requirements. Components for B-3000 Before commencing installation, ensure you have identified the following. 1. Chilled Water Module 2. Installation Requirements 3. Installation Hardware and Dispenser 4. Warranty Water Supply A single cold water supply is required. Supply Pressure: 200 – 1000 Kpa Supply Temperature: 5°C – 30°C Do not install with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection before or after the system.
Installing the dispenser. IMPORTANT: This Billi appliance is to be installed by a licensed trades person in accordance with AS/NZS 3500.1 and AS/NZ 3500.2 and in compliance with applicable state regulatory requirements. For correct operation of this appliance, it is essential to observe the manufacturer’s instructions. 4. Install Dispenser Tap Assembly DISPENSER MUST NOT BE INSTALLED BELOW THE SPILL LEVEL OF THE RECEIVING FIXTURE.
WARNINGS. For continued safety of this appliance it must be installed, operated and maintained in accordance with the manufacturer’s instructions. — Your appliance should be installed by a suitably qualified tradesperson. — For correct operation of this appliance it is essential to observe the instructions as outlined in this booklet. — Filter replacement must be performed at intervals of not more than 6 months. — Use this appliance only as directed in these instructions and only for its designed purpose.
