Installation guide XI Slimline Font – Proud & Flush Mount
Installation requirements. Proud & Flush Mount Components included Before commencing installation, ensure you have identified the following pieces: 1. Font tray 2. Font cover plate set 1 set (3 piece) 3. Sealing Gaskets x 3 4 Drain adapter 5. O-ring 6. M5 x 40mm screw 7. Elbow 3/4” 8. Bush 9. Hose adaptor 10. M6 x 45mm hex bolt x 4 11. M6 Flange nuts x 4 12. Font washer 13. Font mounting bracket x 4 Determine unit location Plan the installation.
Installation procedure. Proud Mount 1. Marking and Drilling Holes a. Cut out hole in benchtop using measurement shown in Diagram 7a on the following page. Bench 2. Fitting Drain Adapter a. Fit O-ring to Drain adapter. b. Fit Drain adapter to tray. Tighten M5 screw, Note: Do NOT over-tighten the screw. c. Drain tube and elbow fitting are to face dispenser mount hole – refer to diagram 1 on previous page. 3. Fitting Billi Font to Benchtop a.
Installation procedure. Hole Cut-Out Dimensions – See Template for actual size, Proud Mount Before using check dimensions are accurate. SIDE 272mm TOP VIEW EXPLODED DIAGRAM Font Not to scale Bench 172mm m .0m 272 FRONT 191.
Installation procedure. Flush Mount 1. Marking and Drilling Holes a. Cut out hole in bench top according to Diagram 7a on page 6. Use appropriate router bits to give R5.0 edges. Bench Font tray 2. Apply thick coat of moisture primer to all cut surfaces 3. Fitting Drain Adapter a. Fit O-ring to Drain adapter. b. Fit Drain adapter to tray. Insert and tighten M5 screw, Note: Do NOT over-tighten the screw. c.
Installation procedure. Hole Cut-Out Dimensions – See Template for actual size, Flush Mount Before using check dimensions are accurate. TOP VIEW 8.5mm 8.5mm 191.0mm 174.0mm 8.5mm Font cut out: 174mm (wide) x 274mm (long) Rebate cut: 5.5mm (deep) 191mm (wide) x 291mm (long) 291.0mm SIDE 274.0mm Corner Radius: 5mm Tolerance: +/- 0.2mm EXPLODED DIAGRAM Font Not to scale 8.
If any problems or difficulties arise contact Billi Australia Pty Ltd: Phone 1800 812 321 (Free call). To validate your warranty refer to the warranty card or validate online at www.billi.com.au For information on our filtration and service contracts please contact Billi Customer Service on 1800 812 321 or service@billi.com.au. Billi Australia Pty Ltd 42 Lucknow Crescent, Thomastown Victoria 3074 Australia Telephone +61 3 9469 0400 Facsimile +61 3 9469 0499 www.billi.com.