- Billion ADSL2+ Wireless Router User's Manual

Regulation Domain: There are seven Regulation Domains for you to choose from,

including North America (N.America), Europe, France, etc. The Channel ID will be

different based on this setting.

Channel ID: Select the ID channel that you would like to use.

Tx Power Level: It is function that enhances the wireless transmitting signal strength.

User may adjust this power level from minimum 0 up to maximum 255.

Note: The Power Level maybe different in each access network user premises

environment and choose the most suitable level for your network.

AP MAC Address: It is a unique hardware address of the Access Point.

AP Firmware Version: The Access Point firmware version.

WPS State: Current WPS state in AP. It is be used for WCN (Windows Connect Now).

 Configured: This AP is be configured via WPS. It is not allow to configure via WCN.

 Unconfigured: This AP is un-configured via WPS. It can be configure via WCN.

Wireless Distribution System (WDS)

It is a wireless access point mode that enables wireless link and communication with other

access point. It is easy to be installed, simply define the peer’s MAC address of the

connected AP. WDS takes advantages of cost saving and flexibility which no extra wireless

client device is required to bridge between two access points and extending an existing

wired or wireless infrastructure network to create a larger network.

In addition, WDS enhances its link connection security in WEP mode, WEP key encryption

must be the same for both access points.

Note: WDS function will disappear automatically if wireless security is not in WEP

mode.

WDS Service: The default setting is Disable. Check Enable radio button to activate this

function.

1. Peer WDS MAC Address: It is the associated AP’s MAC Address. It is important that

your peer’s AP must include your MAC address in order to acknowledge and

communicate with each other.

2. Peer WDS MAC Address: It is the second associated AP’s MAC Address.

3. Peer WDS MAC Address: It is the third associated AP’s MAC Address.

4. Peer WDS MAC Address: It is the fourth associated AP’s MAC Address.

Note: For MAC Address, Semicolon ( : ) or Dash (-) must be included.