tiny USB ISDN TA128 Quick Start Guide This product is designed for the ISDN with Basic Rate Interface.
Quick Start Guide For more detailed instructions on configuring and using the device, please refer to the on-line manual in the installation CD.
tiny USB ISDN TA128 Installing the tiny USB ISDN TA128 Connect your ISDN line to the ISDN S0 RJ-45 jack. Connect the USB cable to the USB port and connect the other end to the PC. Refer to the following figure. For Windows 98: 1. 2 Start Windows. After the opening banner, Windows will tell you that the new device has been detected. You will then see the following screen. Click “Next >”.
Quick Start Guide 2. In the next window, select “Search for the best driver for your device” and click “Next >”. 3. Insert the installation CD into the CD-ROM drive and check “CD-ROM drive” in the next window. 4. Continue through the Wizard, clicking the “Next >” buttons. Windows will start copying files to your system. You will see the following screen prompting for the path of the Windows source files. Please specify a location. Click “OK”.
tiny USB ISDN TA128 5. If you are prompted to restart the computer after Windows finishes installing the driver, press “Yes”. For Windows Me: 1. 4 Start Windows. After the opening banner, Windows will tell you that the new device has been detected. Select “Specify the location of the driver” and click “Next >”.
Quick Start Guide 2. In next window, select “Search for the best driver for your device”. Insert the installation CD into the CD-ROM drive and check “Removable Media”. Click the “Next >” button. 3. Continue through the Wizard, clicking “Next >” at the following screens. Windows will start copying files to your system. Then, click “Finish” in the following window. 4. If you are prompted to restart the computer after Windows finishes installing the drivers, press “Yes”.
tiny USB ISDN TA128 For Windows 2000: 6 1. Start Windows. After the opening banner, Windows will tell you that the new device has been detected. Click “Next>”. 2. In next window, select “Search for a suitable driver for my device”. Click “Next>”. 3. Insert the installation CD into the CD-ROM drive, then in the next window check “CD-ROM drives” and click “Next>”.
Quick Start Guide 4. Click “Next>” to install the driver. When the following windows titled “Digital Signature Not Found” appear, press “Yes” to continue the installation.
tiny USB ISDN TA128 5. Press “Finish” to end the installation. For Windows XP: 8 1. Start Windows. After the opening banner, Windows will tell you that the new device has been detected. Select “Install the software automatically”. Insert the installation CD into the CD-ROM drive and click “Next >”. 2. When next window appears, press “Next >” to continue the installation.
Quick Start Guide 3. Click “Continue Anyway” when the following “Hardware Installation” windows appear.
tiny USB ISDN TA128 4. Press “Finish” to end the installation. ISDN Utility and Diagnostic Program The ISDN Utility includes helpful programs for the tiny USB ISDN TA128, such as a diagnostic program, an uninstallation program, and an on-line manual. After Windows installs the driver of your tiny USB ISDN TA128, the ISDN Utility may be installed automatically. If the ISDN Utility is not installed, you may install it from the installation CD.
Quick Start Guide 4. Press “Loopback Test” to begin the diagnostic procedure. It will make a call from the B1 channel that returns through the B2 channel. The D and B channels will be tested for line integrity. Uninstalling the tiny USB ISDN TA128 If you decide to permanently remove the driver and utility of the tiny USB ISDN TA128 from your system, you must run the uninstallation program from the ISDN Utility program group as follows: 1. Click “Start”, “Programs” and click the “ISDN Utility” item. 2.
