User's Manual

Basic Configuration /

WAN

BEC 6800RUL User Manual

WAN

IP Pass-through Mode: When enabled, BEC 6800RUL is in bridge mode that it does not obtain an

WAN IP address; features such as routing capabilities, NAT, firewall, etc, are being diabled. The client

router that is behind the BEC 6800RUL now obtains an WAN IP address. When disabled, BEC

6800RUL is in router mode that it handles a WAN IP address and all features are become avilable.

ISP Mode: A list of 3G / 4G service providers that is available.

APN: An APN is similar to a URL on the WWW, it is what the unit makes a GPRS / UMTS / LTE call.

The service provider is able to attach anything to an APN to create a data connection. Requirements

for APN assignment varies between different service providers. Most service providers have an

internet portal which they connect a DHCP Server to, giving you access to the internet i.e. Some 3G /

4G operators use the APN ‘internet’ for their portal. The default value of APN is “broadband”.

Username: Enter the username provided by your service provider.

Password: Enter the password provided by your service provider.

Authentication Protocol: Manually specify CHAP (Challenge Handshake Authentication Protocol) or

PAP (Password Authentication Protocol) if you know which authentication type the server is using

(when acting as a client), or the authentication type you want the clients to use when tehy are

connecting to you (when acting as a server). When using PAP, the password is sent unencrypted,

while CHAP encrypts the password before sending, and also allows for challenges at different periods

to ensure that an intruder has not replaced the client.

PIN: PIN stands for Personal Identification Number. A PIN code is a numeric value used in certain

systems as a password to gain access, and authentication. In mobile phones a PIN code locks the

SIM card until you enter the correct code. If you enter the PIN code incorrectly into the phone 3 times

in a row, then the SIM card will be blocked and a PUK code will be required from your network / service

provider to unlock it.

NOTE: when the 3G / 4G SIM card is pulled out and then insert into again, you should again press Apply button to

make 3G / 4G connection take effort, or you can Save config

and Restart the route to reach the same effort.