User's Manual

Advanced Configuration /

Advanced

BEC 6800RUL User Manual

SNMP Access Control

Software on a PC within the LAN is required in order to utilize this function - Simple Network

Management Protocol.

SNMP V1 and V2

Read Community: Specify a name to be identified as the Read Community, and an IP address.

This community string will be checked against the string entered in the configuration file. Once the

string name is matched, user obtains this IP address will be able to view the data.

Write Community: Specify a name to be identified as the Write Community, and an IP address.

This community string will be checked against the string entered in the configuration file. Once the

string name is matched, users from this IP address will be able to view and modify the data.

Trap Community: Specify a name to be identified as the Trap Community, and an IP address.

This community string will be checked against the string entered in the configuration file. Once the

string name is matched, users from this IP address will be sent SNMP Traps.

SNMP V3

Specify a name and password for authentication. And define the access right from identified IP

address. Once the authentication has succeeded, users from this IP address will be able to view

and modify the data.

SNMP Version: SNMPV2c and SNMPv3

SNMPv2c is the combination of the enhanced protocol features of SNMPv2 without the SNMPv2

security. The "c" comes from the fact that SNMPv2c uses the SNMPv1 community string paradigm

for "security", but is widely accepted as the SNMPv2 standard.

SNMPv3 is a strong authentication mechanism, authorization with fine granularity for remote

monitoring.

Traps supported: Cold Start, Authentication Failure.