User's Manual

Queue Config

Queue is a technology of managing congestion providing precautions with the packets storing and

scheduling. Queue Config allows you to configure a QoS queue entry and assign it to a specific

network interface. Each queue entry set here will be used by the classfier to place ingress packets

appropriately.

Note:

the interface set in the WAN> WAN Interface will be list as Default Queue here, and the

parameters listed above can be configured there. For detail, please turn to WAN > WAN Interface

section for help. You can also add other queues to the ATM and PTM interfaces despite of the

default queue.

And Wireless Service queue will be enabled by default if you enable wireless. Also if you enable

virtual APs, the corresponding WMM service queues will be enabled as well.

Name: the queue name.

Key: the item number.

Interface: the queue interface.

Scheduler Algorithm: the QoS Scheduler Algorithm, SP(Strict Priority) or WFQ(Weight Fair

Queuing)

Precedence: the priority identification.

Weight: the weight value, 1-63. the highest is 63.

PTM Priority: the PTM priority, normal or high.

Enable: check the enable check-box, then press Enable to activate the queue. If you want to

disable this queue, you can uncheck the corresponding check-box and press Enable, the queue will

be disabled.

If the queue is enabled, you will see a tick, like . Otherwise, the queue is disabled.