User manual

101
Advanced
Here users can set some advanced parameters about wireless.
Band: select frequency band. Here 2.4GHz.
Channel: Allows channel selection of a specific channel (1-7) or Auto mode.
Scan Used Channel: Press the button to scan and list all channels being used.
Auto Channel Timer (min): The auto channel times length it takes to scan in minutes. Only
available for auto channel mode.
802.11n/EWC: select to auto enable or disable 802.11n.
Bandwidth: Select bandwidth. The higher the bandwidth the better the performance will be.
Control Sideband: only available for 40MHz. It allows you to select upper sideband or lower
sideband. Sideband refers to the frequency band either above (upper sideband) or below (lower
sideband) the carrier frequency, within which fall the spectral components produced by modulation
of a carrier wave.
802.11n Rate: This allows you to select the fixed transmission rate or auto.
802.11n Protection: turn off for maximize throughput. Auto for greater security.
Support 802.11n Client Only: turn on the option to only provide wireless access to the clients
operating at 802.11n speeds.