BiPAC 7402(G)X(L) Series 3G/ ADSL2+ (802.
Quick Start Guide
Billion BiPAC 7402(G)X(L) Series ADSL2+ Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON CD-ROM.
Quick Start Guide Hardware Overview BiPAC 7402X(L) does not support 802.11g and WPS functions. The Front LEDs Lit orange red when power is ON. Lit red means system is fail. Lit green when the system is ready. Lit when connected to an Ethernet device. Green for 100Mbps; Orange for 10Mbps. Blinking when data is Transmitted / Received. Lit green when the wireless connection is established. Flashes when the device sending /receiving data.
Billion BiPAC 7402(G)X(L) Series ADSL2+ Router Hardware Connection Hardware Installation 1. Power Connection Plug the supplied power adapter to the wall jack and the other side to the router. Please note that the plug type may differ according to different country. 2. LAN Connection Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the other side to the PC’s Ethernet interface.
Quick Start Guide 3. USB Connection The USB 2.0 port supports 3G/ HSDPA modem connectivity: users can conveniently access Internet via 3G, eliminating the limitations of the wired network. This solution also employs an auto fail-over feature to ensure always-on connectivity for SOHO users. 4. ADSL Connection Connect the supplied RJ-11 phone cable to the router’s ADSL port, and the other side to the phone jack on the wall. 5.
Billion BiPAC 7402(G)X(L) Series ADSL2+ Router 6. Splitter/ Micro-filter Connection The Splitter / Micro-filter are important for ADSL installation, they help direct high-frequency signals to the ADSL modem & low frequency signals to the telephone or other analogue device to prevent inter-modulation distortion & get good speed/stable ADSL sync rate. a) Splitter connection If the installation has only a single telephone and a single ADSL modem, then a splitter can be employed.
Quick Start Guide Connecting to the Router 1. Open the web browser and type http://192.168.1.254 in the browser's address box. This number is the default IP address for this router. Press Enter. 2. A username and password window will appear. The default username is “admin”, and password is “admin”. Press OK to proceed. 3. You will get a status report web page and main menu screen. Please see the relevant sections of user manual for detailed instructions on how to configure your router. Troubleshooting 1.
