BiPAC 7402NX(L) 802.
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER’S MANUAL ON CD-ROM. Package Contents BiPAC 7402NX(L) 802.
Hardware Overview BiPAC 7402NX(L) has 802.11n draft Wireless Access Point and Giga Switch Support. The Front LEDs Lit when power is ON. Lit red when POST (Power On Self Test) failure (not bootable) or device malfunctions Lit when connected to an Ethernet device. Green for 1000Mbps; Orange for 100Mbps. Without shining for 10Mbps. Blinking when data is Transmitted / Received Lit green when the wireless connection is made. Flashes when sending/receiving data.
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router Hardware Connection Hardware Installation 1. Power Connection Plug the supplied power adapter to the wall jack and the other side to the router. Please note that the plug type may differ according to different countries. 2. LAN Connection Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the other side to the PC’s Ethernet interface.
3. USB Connection The USB 2.0 port supports 3G/ HSDPA modem connectivity; users can even more conveniently enter access with 3G service to eliminate the limitation of the wired network and extends the last-mile service wirelessly. Incorporated the wired environment, the solution applies the auto fail-over feature to provide various applications and ensure always-on connectivity for SOHO users. 4.
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router 5. Splitter/ Micro-filter Connection Splitter / Micro-filter are important for ADSL installation. It helps high-frequency signals are directed to the ADSL modem, and low-frequency signals are directed to the telephone or other analog voice-channel device to prevent inter-modulation distortion and get good speed and stable ADSL sync rate.
Setup Utility After you complete the hardware installation, insert the CD-ROM to the CD-ROM drive to perform Setup Utility for network configuration. The Setup Utility will auto-run. Follow the step-by-step configuration wizard, the utility will guide you complete the basic network configuration. Troubleshooting 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem.
