User manual

44
Select DSL Link Type: select the link type (protocol), EOA, PPPoA, IPoA.
Select Connection Mode:
L Default Mode: this mode only allows single service over one connection.
L VLAN MUX Mode: this mode allows multiple services over one PVC.
The two modes can be different in WAN service configuration. And PPPoA and IPoA do not use
Ethernet frames for data transfer so they cannot work with VLAN Mux feature. Thus, Connection
Mode Parameter will be hided if you select PPPoA or IPoA in Link Type.
Encapsulation Mode: select the encapsulation mode from the drop-down menu according to the
link Type.
Service Category: select the service category from the drop-down menu to determine your service
category.
L UBR without PCR: UBR(Unspecified Bit Rate), PCR(Peak cell Rate)
UBR is a kind of QoS, which doesn’t provide assurance about the cell latency, the bit loss rate etc,
it is a best-effort service.
Select IP QoS Schedule Algorithm: select the Schedule Algorithm, SP(Strict Priority), always
sends the packets with the highest priority, WFQ(Weighted Fair Queuing), an automatically
bandwidth adjusting method, sharing the available bandwidth when congestion happens, the
bandwidth is assigned according to the priority and the weight value. Turn to the Quality of Service
> Queue Config section for more information.
Precedence of the default queue: default 8(lowest)
Weight Value of default queue: enter the value, 1-63, the highest is 63.
MPAAL Group Precedence: select the precedence identification, 1-8, the highest is 1.