User manual

Click Apply/Save to save and the added queue will be listed as below.

Enable: check the enable check-box, then press Enable to activate the queue. If you want to

disable this queue, you can uncheck the corresponding check-box and press Enable, the queue will

be disabled.

Remove: To delete the QoS rule from the table, check Remove checkbox then click Remove

button to delete the selected item.

Note: only the queue added via the above mode can be directly removed here, the default queue

can’t be removed here, if you want to remove them, remove the interface in LAN2 Interface> ATM

Interface section.

Note: In ATM mode, maximum queues can be configured: 16

For each Ethernet interface, maximum queues can be configured: 4.