Technical data

TeleWell TA 128K

2.2 AT komennot

Käsikirjan loppuosuus on vain englanniksi koska sitä tarvitaan vain

erikoiskäyttöön ja ammattilaisten lisäohjeistukseksi.

With the exception of the command A/ (Repeat command) all commands begin with

the prefix AT and are terminated with <↵>. Corrections in a command line are done

with <BACKSPACE>. A command line has a maximum of 80 characters. The

command line is automatically cancelled by longer input. Blanks are ignored,

capital/small letters are not significant.

The parameter settings of the TA 128K obtained when using the AT commands can

be permanently stored (AT&W) and are not lost by resetting or by leaving the AT

command mode.

To enter the AT command mode during an active data connection you must use the

following sequence ("Escape sequence"):

at least 1 sec pause <+><+><+> 1 sec pause

The time gap between all three plus signs may not exceed 1 sec.

The escape sequence is transmitted transparent to the remote device.

Tuetut komennot:

A/ Repeat last command line

This command repeats the commands of the last entered command line.

Note: No prefix AT is required.

A Accept incoming call

Using this command you can accept an incoming call, if automatic call acceptance is

not set (Register S0 = 0). An incoming call is displayed by the message “RING“ or

the code “2“.

Must be the last command in an AT command line.

ATA[//<UUS1data>]

UUS1data transmitted data with UUS1 signalling

B B channel protocol