User's Manual

UM600410 Rev C, page 75 of 81
User Manual – Elo I-Series 4.0
Notice to Users in Canada for IC compliance: This equipment complies with the Class B (for the ESY10I1D and ESY15I1D
models), Class A for the ESY22I1D model limits for radio noise emissions from digital apparatus as established by the Radio
Interference Regulations of Industrial Canada.
For the ESY22I1D models: CAN ICES-003(A) / NMB-003(A)
For the ESY10I1D and ESY15I1D models: CAN ICES-003(B) / NMB-003(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20(FCC/IC) cm from all persons and must not be located or operating in con junction with any other antenna or trans
mitter. Les antennes utilisées pour ce transmetteur doivent être installé en considérant une dis tance de séparation de toute personnes d’aumoins 20 (F
CC/IC) cm et ne doivent pas être localisé ou utilisé en conflit avec tout autre antenne ou transmetteur.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the
equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for
emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which means that the
equipment has been tested to the following Directives and Standards: This equipment has been tested to the requirements for the CE Mark as required
by EMC Directive 2014/30/ EU as indicated in European Standard EN 55032 Class B (for the
ESY10I1D and ESY15I1D models), Class A for the ESY22I1D model and the Low Voltage Directive 2014/35/EU as indicated in
European Standard EN 62368-1.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to this manual
the equipment may cause interference with radio and television communications. There is, however, no guarantee that
interference will not occur in any particular installation due to site-specific factors.