User's Manual

Configuring Router

Network Settings and Software Installation

This chapter will show you how to configure the Bluetooth PAN to function in your network

and gain access to the Internet through your Internet Service provider (ISP). Your ISP may

require the use of a Host Name and Domain Name. Furthermore, you will need to set the

WAN Configuration Type on the Router’s Setup tab from the information given by your ISP.

You will need this setup information from your ISP. If you do not have this information,

please contact your ISP before proceeding. The instructions from your ISP tell you how to

set up your PC for Internet access. Since you are now using this Bluetooth PAN to share

Internet access among several computers, you will use this setup information for detailed

configuration.

*Please plug the LAN cable into the PAN bridge and power it on.

*Please make sure your Bluetooth client is connected to this access point, and your

browser proxy setting is disabled.

Start-up and Log in

Activate your browser, and disable the proxy or add the IP address of this product into the

exceptions. Then, type this product’s IP address in the Location (for Netscape) or Address

(for IE) field and press ENTER. For example: http://192.168.18.1

. After the connection is

established, you will see the web user interface of this product. There are two appearances

of web user interface: for general users and for system administrator. Before you make any

changes to the access information. Leave the Password field empty with “root” in the User

field, and click the Logon button (you can configure the user/password later in the

“Change Password Page”).

Open your web browser, and enter 192.168.18.1 into the web browser’s Address bar, then

press the Enter key.

This product provides a Web based configuration scheme that is configurable by Netscape

Communicator or Internet Explorer. This approach can be adopted in any MS Windows or

Macintosh platform.