Bluetooth Headset (GHSBTC) Qu ick Start Gu id e
Product Parts 4 1 5 1. Talk button (Power/ MFB) 2. Volume up button 3. Volume down button 4. OLE D Display 5.
Man Machine Interface 1. Button Function Button 1. Talk Action Function Short Click Answer an incoming call Short Click Voice recognition dial Short Click To establish an RFCOMM with a paired AG if the headset is in standby mode.
Button Action Function Press and hold for Show battery status in OLED display longer than 2 seconds 5.Volume UP and Volume Down Press and hold for Enter pairing mode if the headset is in standby mode longer than 2 seconds 2. OLE D Display # Display Icon 1 Function COMME NT If exceed 10 digits, display each 3 sec Caller ID 2 Standby mode 7 sec display time and rolling.
# Action Sound played 3 Press Talk button for 2 seconds 2 beeps. (Do Do). 4. Press Talk and V+ button for 2 second 2 beeps. (Do Do). 5. Press V+ and V- button for 2 seconds 2 beeps. (Do Do). 6 Volume level reaches the max/Min 2 beeps 7 Active Connect to AG Fail 1 beep (Do) 8 Ring tone (Out-of-Band Ring) Ascending melodic; (Do-Ra-Mi-Fa-So-La-Si-Do) 9 Low Battery Indicator 1 beep(Do) every 5 sec 10 Pair Operation Fail 1 beep (Do) 4.
# Event Flashing Pattern 7 Press and hold for Flash 2 times longer than 2 ON (250ms) seconds COMMENT To indicate user to release button, and then long press function will be workable OFF (250ms) 8 Press and hold V+ Flash 2 times and V- for longer ON (250ms) than 2 seconds To indicate user to release button, and then Pair operation will be executable OFF (250ms) Operation . Charging the battery Before using the Bluetooth headset, you will have to charge the battery. 1.
To POWER OFF: Press and hold the Talk button for at least 5 seconds when the Headset is in power ON mode. The OLED display will show powered off. and a descending melodic tone (Si-Fa-Do) will be played before the Headset is NOTE: if there is a charger plugged in, the system won’t be able to be powered off. . Pair with a Mobile phone AG To Enter Pairing mode: 1. 2. 3. 4.
. Voice recognition Dial 1. 2. 3. Make sure the Headset has a RFCOMM connection with an AG. Press the Talk button for will activate the voice dial functionality in AG -if it is supported in the Mobile phone, and any voice record will be prepared in the Mobile phone in advance. Speak the name on headset. .Adjust the Volume 1. 2. Make sure the Headset has an RFCOMM connection with an AG (in HandsFree mode) OR there is an SCO connection with an AG (in Headset mode).
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.