User's Manual

Modifications

The FCC requires the user to be notified that any changes or

modifications made to this device that are not expressly approved

by the Manufacture may void the user’s authority to operate the

equipment.

Connections to Peripheral Devices

Connections to this device must be made with shielded cables with

metallic RFI/EMI connector hoods to maintain compliance with

FCC Rules and Regulations.

SAR Exposure

This device has been tested for compliance with FCC RF Exposure

(SAR) limits in typical flat configurations.

In order to comply with SAR limits established in the ANSI C95.1

standards, it is recommended when using a CF card that the

integrated antenna is positioned more than 1.5cm from your body

or nearby persons during extended periods of operation.

Declaration of Conformity

This device complies with Part 15 the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

European Notice

Products with the CE Marking comply with both the EMC Directive

(2004/108/EC) and the Low Voltage Directive (2006/95/EC) and

R&TTE Directive (1999/5/EC) issued by the Commission of the

European Community.

Compliance with these directives implies conformity to the

following European Norms:

• EN55022: 2006, CLASS B

• EN61000-3-2: 2006, CLASS D

• EN61000-3-3: 1995+A1: 2001+A2: 2005