User's Manual

User*s Manual

5. Troubleshooting

5.1 C

ANNOT CONNECT TO A PAIRED DEVICE

Paired devices are always displayed in My Bluetooth Places, even if the remote device

out of range or not powered up.

Verify that the remote member of the pair is within radio range and powered up and then

attempt the connection again.

5.2 C

ANNOT DISCOVER SERVICES ON AN UN

PAIRED REMOTE DEVICE

The remote device may not be powered up or may be out of range.

* Verify that the remote device is powered up.

* Verify that the remote device is in Connectable mode (Bluetooth Configuration

Panel

> Accessibility tab).

* Perform a Search for Devices to verify that the device is within range.

5.3 D

IAL

ETWORKING SERVICE DOES NOT START

The Dial-up Networking service will not start unless a properly configured modem is

attached to the server.

* Verify that the modem is usable as a local device from the server.

* In the Bluetooth Configuration Panel, Local Services tab, double-click the Dialup

Networking service:

* Click the down arrow in the Modem field and select the modem that will be used to

dial out

* Click the OK button

* Click the OK button to close the Bluetooth Configuration Panel.

5.4 H

OW DO

DETERMINE THE

LUETOOTH

EVICE

DDRESS

(BDA)

OF MY

HARDWARE DEVICE

In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section,

select

the device you want to determine the address of. In the Device Properties section

of the

dialog box, the fourth entry, Device Address, is the BDA of the selected Bluetooth

device.

P(13)網頁