MM Owner’s Manual BILLY GOAT MULCH MULE DEBRIS LOADER VACUUM Owner's Manual DL2500SMM Part No 791108 1 Form No F111008B
MM Owner’s Manual ABOUT THIS MANUAL THANK YOU for purchasing a BILLY GOAT ® Mulch Mule Vacuum. Your new machine has been carefully designed and manufactured to provide years of reliable and productive service. This manual provides complete operating and maintenance instructions that will help to maintain your machine in top running order. Read this manual carefully before assembling, operating, or servicing your equipment.
MM Owner’s Manual SERIAL PLATE DATA Record the model number, serial number, date of purchase, and where purchased. Purchase Date: Purchased From: Specifications MM2500S Engine: HP 25 (18.6kW) Engine: Model EH720-DS0510 Engine: Type SUBARU Engine: Fuel Capacity 6 gal.. (22.7 L) REMOTE TANK Engine: Oil Capacity 1.63 qt. (1.55 L) Total Unit Weight: 326 lbs (147.9 kg) 25 Overall Height (m) Overall Height with optional trailer 91”(2.31m) Overall Width 32 ¼” (0.82m) Overall Length 60” (1.
MM Owner’s Manual GENERAL SAFETY INSTRUCTIONS and SYMBOLS The safety symbols shown below are used throughout this manual. You should become familiar with them before assembling, operating, or servicing this equipment. This symbol indicates important information that will prevent injury to yourself or others. This symbol indicates ear protection is recommended when operating this equipment. This symbol indicates eye protection is recommended when operating this equipment.
MM Owner’s Manual DO NOT run this equipment indoors or in any poorly ventilated area. Refueling outdoors is recommended. DO NOT refuel this equipment while the engine is running. Allow engine to cool for at least two minutes before refueling. DO NOT store gasoline near an open flame. DO NOT remove gas cap while engine is running. DO NOT start or operate engine if strong odor of gasoline is present. DO NOT start or operate engine if gasoline is spilled.
MM Owner’s Manual SOUND SOUND LEVEL 93 dB(a) at Operator Position Sound tests were conducted in accordance with 2000/14/EEC, and were performed on 6/18/07 under the conditions listed below. Sound power level listed is the highest value for any model covered in this manual. Please refer to serial plate on the unit for the sound power level for your model. General Conditions: Temperature: Wind Speed: Wind Direction: Humidity: Barometric Pressure: Cloudy 74oF (23.2oC) 3.7 mph (21.6 kmh) South 83.5% 29.
MM Owner’s Manual INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT Mulch Mule Vacuum. If any labels are damaged or missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part numbers are provided for convenience in ordering replacement labels. The correct position for each label may be determined by referring to the Figure and Item numbers shown.
MM Owner’s Manual PACKING CHECKLIST Your Billy Goat is shipped from the factory in two cartons (one for the unit and one for the exhaust hose) and is completely assembled except for the exhaust elbow, nozzle, handle loop for nozzle, hose booms, hose bands, hose coupler, hose clamps exhaust hose and related hardware. READ all safety instructions before assembling unit. TAKE CAUTION when removing the unit from the box.
MM Owner’s Manual ASSEMBLY 1. SECURELY ATTACH unit to the bed of a truck or to a trailer, so that the exhaust discharges into an enclosed container. NOTE: This unit must be securely mounted to the bed of a truck or to a trailer before operating. 2. ATTACH hose to housing intake, using hose clamp (item 22) making sure to place the safety switch under the clamp. Then place the clamp (item 22) over around the end of the hose to be attached to housing.
MM Owner’s Manual Typical on both sides MOUNTING: Main unit GENERAL: Unit must be securely mounted to a trailer, truck bed, or other similar surface before use. Do not use this unit in a freestanding position. Unit is not stable until it has been secured in place. Secure unit by bolting through the base of the unit and through the mounting surface using 3/8" dia. bolts, with washers and locking nuts (see fig. 1) Fig.
MM Owner’s Manual VACUUMING OPERATION EXHAUST DIRECTION & DISTANCE: Exhaust direction and distance are controlled by the rotation of the exhaust elbow. Typically debris is aimed to discharge to the rear of the container. The direction of discharge is adjusted by turning the crank on the exhaust elbow clamp and rotating the elbow to the desired direction. NOTE: Elbow is heavy. Use caution when adjusting. Never stand directly under the elbow while adjusting direction of exhaust.
MM Owner’s Manual MAINTENANCE PERIODIC MAINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every use Every 5 hours (daily) Every 10 Hours Every 25 Hours z Inspect for loose, worn or damaged parts. Check engine oil and air filter z Clean hose z Engine (See Engine Manual) z Inspect battery for damage or leak Keep engine free of debris z z Check battery terminal for corrosion z Check for excessive vibration IMPELLER REMOVAL 1.
MM Owner’s Manual Troubleshooting P ro b le m A b n o rm a l vib ra tio n . P o s s ib le C a u s e L o o s e o r o u t o f b a la n c e im p e lle r o r lo o s e e n g in e · N o zzle b u rie d in d e b ris . C lo g g e d h o s e o r e x h a u s t. E x c e s s iv e q u a n tity o f d e b ris . B a tte ry is lo w o r d e a d . B a tte ry C a b le is d is c o n n e c te d o r b a tte ry te rm in a l is c o rro d e d . H a rn e s s w ire is b a d o r d is c o n n e c te d fro m in te rlo c k s w itc h .
MM Owner’s Manual PARTS DRAWING MM Part No 791108 14 Form No F111008B
MM Owner’s Manual PARTS LIST ITEM NO. 1 2 3 4 5 6 7 9 10 11 12 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 DESCRIPTION LABEL WARNING EXPLOSIVE FUEL LABEL OPEI WARNING WASHER TWISTED LOCK 7/16" GRIP 1 1/4 ID X 9.
MM Owner’s Manual MAINTENANCE RECORD Date Part No 791108 Service Performed 16 Form No F111008B