Self-Propelled Vacuum Chipper Operator Owner's Manual

Part No. 890316 Form No. F082195D
Page 3 of 12
For your safety and the safety of others, these directions should be followed:
Use of Ear Protection is recommended while
operating this machine.
Do not operate this machine without first reading
owner's manual and engine manufacturer's manual.
Use of Eye and Breathing protection is recom-
mended when using this machine, especially in dry
and dusty conditions. Optional bag cover directs dust
toward ground, away from the operator.
·DO NOT place hands or feet inside nozzle intake opening,
near debris outlet or near any moving parts.
·DO NOT start engine without debris bag and quick discon-
nect connected firmly in place to exhaust outlet.
·DO NOT start or operate machine with debris bag zipper
open.
PUT OIL IN ENGINE BEFORE STARTING.
Read all safety and operating instructions
before assembling or starting this unit.
Debris Bag
890306
Check
These items should be included in your carton. If
any of these parts are missing, contact your dealer.
QUICK DISCONNECT
Fig. 2
·DO NOT operate during excessive vibration.
·DO NOT remove bag until engine has been turned off and has
come to a complete stop.
·DO NOT remove hose kit cap on nozzle until engine has been
turned off and has come to a complete stop.
·DO NOT operate machine with hose cap, bag or hose removed.
·DO NOT use this machine for vacuuming exclusively sand,
dust, fine dirt, rock, glass, string like material, grain, rags,
cans, metal, bark or water.
·DO NOT operate this machine on slopes greater than 20%.
·DO NOT pick up any hot or burning debris, or any toxic or
explosive material.
·DO NOT allow children to operate this equipment.
Check
Tamper
890229
GENERAL SAFETY
ASSEMBLY
PACKING CHECKLIST
9
10
11
Check
Tecumseh
P/N181-656-1 English
Check
Literature Assy
890325
Literature
Assy
Check
Connector
Quick
Disconnect
890176
8
74
73
30
27
6
1. ASSEMBLE Lift upper handle (item 6), remove items 8, 73, 74, & 30 from
lower handle (item 27). Attach upper and lower handle as shown,
and securely tighten folding handle knobs (item 73),while holding head of
screw (item 8) firmly against upper handle.
2. UNFOLD the debris bag (item 1) and fasten bag neck to bag quick
disconnect (item 83). Attach firmly to housing exhaust (item 52) see fig. 2.
3. ATTACH bag hanger strap to bag supports (item 11), preassembled to
upper handle.
4. INSTALL tamper (item 85) in chipper hopper (see page 7).
5. CONNECT spark plug wire.
Your Billy Goat is shipped from the factory in one carton,
completely assembled except for the upper handle, debris bag,
tamper and bag quick disconnect.
Engine
Manual