Owners manual

E4
-
WM5
-
Y542A00
MOUNTING INSTRUCTION
created: 01.08.18 E4-WM5-Y542A00_0 Page 11 of 15 latest revision:
S. Apply non-permanent thread locker on the end of each of the screw threads of the 4 supplied M10
Flange Head Cap Screws (BOM item #3). Then install the reservoir support plate assembly to the
sway bar spacer as shown in the image below by placing these screws through the holes in the
reservoir support plate and threading them into the threaded holes in the sway bar spacer with a
15mm socket (2 per side).
Torque supplied M10 Flange Head Cap Screws to 37 ft-lb (50 Nm).
T. Slide the reservoir until the bracket is approximately in the center of the reservoir.
U. Tighten the Socket Head Cap Screw that was partially threaded in on Step Q with a 5mm hex key.
Torque Socket Head Cap Screw to 6 ft-lb (8 Nm).
V. Re-attach and torque outer tie rod, control arm to knuckle ball joint nut, and sway bar link according to
service manual specifications.