Owners manual

E4
-
WM5
-
Y542A00
MOUNTING INSTRUCTION
created: 01.08.18 E4-WM5-Y542A00_0 Page 12 of 15 latest revision:
W.
Using the 3 provided zip ties, relocate the ABS line that is attached to the bracket on the upright
knuckle as shown in the following steps (same process on other side). Be careful to not damage the
ABS line during this process.
X.
Clip and remove the OE zip tie shown in the image below (circle #1) and remove ABS line from
bracket (circle #2).
Y.
Move ABS line to outer side of bracket as shown in the image below and secure it with the 1st
supplied zip tie (circle #3). Trim excess zip tie length after installation. Install the 2nd supplied zip tie
as shown (circle #4). Pull tight and trim excess zip tie length after installation.
1
2
3
4