Owners manual

E4
-
WM5
-
Y542A00
MOUNTING INSTRUCTION
created: 01.08.18 E4-WM5-Y542A00_0 Page 8 of 15 latest revision:
O. Apply non-permanent thread locker on the end of each of the screw threads of the 4 supplied M10
Flange Head Cap Screws (BOM item #3). Then place these screws through the holes in the OE sway
bar bracket and thread into the threaded holes in the supplied sway bar spacer with a 15mm socket
(2 per side) as shown in the 2 images below.
Torque supplied M10 Flange Head Cap Screws to 37 ft-lb (50 Nm).