Owners manual

E4
-
WM5
-
Y542A00
MOUNTING INSTRUCTION
created: 01.08.18 E4-WM5-Y542A00_0 Page 9 of 15 latest revision:
P. Apply non-permanent thread locker on the end of each of the screw threads of the 4 supplied M8
Flange Head Cap Screws (BOM item #8). Then place these screws through the holes in the supplied
reservoir support plate (BOM item #5) and thread into the threaded holes in the supplied reservoir
clamp (BOM item #7) as shown in the depictions below using a 13mm socket (2 per side).
Torque supplied M8 Flange Head Cap Screws to 18 ft-lb (25 Nm).
Q. Apply non-permanent thread locker on the end of each of the screw threads of the 2 supplied Socket
Head Cap Screws (BOM item #9). Place the Socket Head Cap Screw up through the pinch bolt hole
in the reservoir clamp as shown in the depictions below and thread in with a 5mm hex key (1 per
side). Thread it in enough so the Socket Head Cap Screw won’t fall out, but loose enough so you can
still slide the clamp onto the reservoir in the next step.