Owners manual

E4
E4E4
E4
-
--
-
WM5
WM5WM5
WM5
-
--
-
Y
YY
Y
446
446446
446
A00
A00A00
A00
MOUNTING I
MOUNTING IMOUNTING I
MOUNTING I
N
NN
N
STRUC
STRUCSTRUC
STRUC
TION
TION TION
TION
erstellt am: 11.01.13 E4-WM5-Y446A00_0 Page 1 of 3 zuletzt geändert am
IMPORTANT:
PLACE CIRCLIP IN APPROPRIATE GROOVE TO ADJUST RIDE HEIGHT.
Use appropriate tools to move the circlip. Ensure that the circlip is fully seated in the groove after moving it (you should be able to
rotate it manually in the groove). Install the spring seat in the direction shown only. The circlip must fit completely in the groove
inside spring seat (A). Improper installation will cause permanent damage to the shock!
** Ride heights indicated are typical. Actual ride height is influenced by which factory suspension the vehicle is equipped with and
its condition; optional equipment and accessories on your vehicle, and other vehicle modifications such as replacement coil springs,
wheel and tire combinations, etc.
Modifying/lifting the suspension to your vehicle may raise its center of gravity and may make it more susceptible to loss of control
and/or rollover, which may result in death or serious injury. We strongly recommend that you offset the loss of rollover resistance as
much as possible by increasing tire track width, and that you equip the vehicle with a functional roll bar and cage system.
Wear seat belts and shoulder harnesses at all times, and avoid situations where a side rollover may occur.
0.75” AVERAGE LIFT**
1.3” AVERAGE LIFT**
1.9” AVERAGE LIFT**
2.5” AVERAGE LIFT**
SPRING SEAT
CIRCLIP
DETAIL A