Safety Information

ManualsBrandsBILT HARD ManualsAutomotive200 Amp 40 Amp 6V/12V Wheeled Battery Charger and Engine Starter, Heavy Duty Fully Automatic Battery Charger and Maintainer for Cars, Trucks, SUVs, Marine, RV Batteries

6V 2A-10A • 12V 2A-20A BATTERY CHARGER

OWNER’S MANUAL

• Suitable for AGM, GEL, STD Batteries

• ETL Certified

• CEC/DOE Compliant

• Electrical Rating 120VAC / 60Hz

• 200A Engine start

• Short Circuit Protected

• Reverse Polarity Protected

• Overheat Protected

• Spark Proof

• 1 Year Warranty

BR – CGES1240

Summary of content (6 pages)

PAGE 1
BR – CGES1240 6V 2A-10A • 12V 2A-20A BATTERY CHARGER OWNER’S MANUAL • Suitable for AGM, GEL, STD Batteries • ETL Certified • CEC/DOE Compliant • Electrical Rating 120VAC / 60Hz • 200A Engine start • Short Circuit Protected • Reverse Polarity Protected • Overheat Protected • Spark Proof • 1 Year Warranty
PAGE 2
WARNING This manual contains important safety instruction, read and understand before operation! a. Someone should be within range of your voice or close 1. SAVE THESE INSTRUCTIONS. This manual contains enough to come to your aid when you work near a lead- important safety and operating instructions. You may need to acid battery. refer to these instructions at a later date. b. Have plenty of fresh water and soap nearby in case 2. CAUTION.
PAGE 3
SPECIFICATION Item Code BR – CGES1240 Input Voltage 110V AC 60Hz Output Voltage 6V 12V Output Current 2 A, 40 A Boost 2 A, 10A, 40 A Boost Starting settings 12V, 200A 5 second maximum with 180 second minimum rest Battery Cables 6' Red = Positive Black = Negative Assembly Attach Wheels to Axle Attach Foot 1. Slide Wheel Bearing (37) onto Axle (35). Attach Foot (30) with four Tapping Screws (29). 2. Slide Wheel (17) onto Axle. 3.
PAGE 4
DISPLAY PREPARE TO OPERATION TO PREVENT SERIOUS INJURY: TO PREVENT SERIOUS INJURY: Wear ANSI-approved splash-resistant safety goggles and heavy-duty rubber work gloves whenever connecting, disconnecting, or working near battery. Battery acid can cause permanent blindness. Assemble Charger/Starter according to Assembly Instructions before use. If necessary to remove battery from vehicle to charge, always remove grounded terminal from battery first.
PAGE 5
OPERATION Charging Battery Installed in Vehicle Charging Battery Installed in Vehicle WARNING! Do not use Start setting to charge batteries. WARNING! Do not use Start setting to charge batteries. Use to jump start only. Use to jump start only. DO NOT CHARGE A FROZEN BATTERY. DO NOT CHARGE A FROZEN BATTERY. COLD BATTERIES: Begin charging at lowest rate, increase rate as battery reaches normal temperature.
PAGE 6
ENGINE STARTING Connect NEGATIVE (BLACK) clip to vehicle NOTICE: Some vehicles with onboard computers may be damaged from the high-current starting output. Thoroughly read the vehicle service manual before using this procedure. chassis or engine block away from battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block. WARNING! Do not use Start setting to charge b.