manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
7 / 16
Assembly page 7/16
Fax [phone]
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help: repairs made by unqualified persons can be dangerous and render void the warranty.
ASSEMBLY (only for mod. VI90.EU)
Attention: the fan can be used only when completely and correctly assembled, that is complete with its
base and support and protection grid. If in doubt, have the appliance checked or assembled by a qualified
professional person. For assembly, refer to below figure.
• Join the two wheels through the holes in the bracket base.
• Attach the two wheels by inserting the cotter pin into the hole, fold the ends of the cotter pin in order to
prevent it sliding out.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
• Please put the appliance on a secure surface:
− verify that the feet and wheels are good positioned
− verify that the area around the surface is clean, without dust
• The fan can be manually adjusted up and down by the air grating and according to his inclination
• Please insert the plug into the socket and select the speed desired turning the knob (6). It is
positioned on the back side: position “0” off, position ”1” minimum speed, position” 2” maximum
speed.
• To switch off the appliance, turn the knob in “0” position and pull out the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.