manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
Fax [phone]
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do
not use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger. Attention: any stickers or advertising material applied to the grid removed before using
the appliance. The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate
(230V~
50Hz)
correspond to those of the electricity supply network. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with another
more suitable type by professionally qualified personnel, who will make sure that the section of
the wires of the outlet is appropriate for the absorbed power of the heater. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they must conform
to existing safety standards and their current capacity (amperes) must not be less that the
maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters)
to avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help: repairs made by unqualified persons can be dangerous and render void the
warranty.
• Some models can be provided with perfume diffusers to refresh the environment, ideal for offices,
sitting rooms, etc…To diffuse the aromas, moisten the filter with a few drops of oil/essence (not
included). Do not exaggerate the quantity because the oxidising effect of the oil could damage the
paint on the fan. Attach the diffuser to the front or back grid (always outside) by means of the
hooks on the back.
8/24
Assembly page 8/16