manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
Fax [phone]
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base and support and protection grid. If in doubt, have the appliance checked or assembled by a
qualified professional person.
Attention: always unplug the appliance before you assemble.
For assembly, refer to figure.
1. Motor shaft
2. Oscillation button
3. Body
4.
Pole attachment ring
nut
5. Cover
6. Feet attachment screw
7. Foot
8. Selector
9. Fixed pole
10. Adjustable pole
11. Handle
12. Front grille
13.
Fan attachment ring
nut
14. Cable rewind
15. Grille attachment ring
nut
16. Rear grille
17. Fan
18. Body ring nut
Upright
1) Cross the two feet (7) and fasten them to the fixed rod (9) using the 4 screws provided, cover the
joint between the feet and the fixed rod using the cover (5).
2) Lengthen the adjustable rod (10) to the required height and lock tightly using the rod fixing ring
nut (4).
Ventilator
3) Fasten the rear grid (16) to the body,
so that the handle (11) appears at the top, positioning the
corresponding pins and holes, and lock using the appropriate ring nut (15).
4) Insert the fan (17) on the motor shaft (1) and lock with the appropriate ring nut (13) turning it
tightly anti-clockwise.
5) Couple the front grille (12) to the rear one (16) locking it with the closing hooks. For safety
reasons, you must make sure that it is attached by using the screws and nuts provided, which are
9/24
Assembly page 9/16