manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
8 / 28
Assembly page 8/16
Fax [phone]
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on
the appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is
covered or positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help: repairs made by unqualified persons can be dangerous and
render void the warranty.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete
with its base and support and protection grid.
If in doubt, have the appliance checked or assembled by a qualified professional person. For
assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
1) “L” screws
2) Counterweight
3) Base
4) Fixed rod
5) Rod fastening screw
6) Adjustable rod
7) Safety screws
8) Nut with retaining screw grip
9) Cord
10) Clutch screw (up / down)
11) Motor housing
12) Oscillation button
13) Switch
14) Screw with nut
15) Front grill/protective screen
16) Fan
17) Fan fixing screw
18) Rear grill fixing screws
19) Rear grill
20) Motor shaft
21) Round-head retaining screw
1) Insert rod (4) into the base (3) and counterweight (2), inserting it into its seat, and lock it
with the "L" screw and washer (1).
2) Extend the adjustable rod (6) to the desired height and secure by tightening the fixing rod
fastening screw (5).