manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
9 / 28
Assembly page 9/16
Fax [phone]
3.Place the motor housing (11) on the adjustable column
a.Insert the
retaining screw
(21) into its seat,
the label "F" on
the column must
be at the front
b. Tighten the locking
screw (7)
c.Lock the retaining
screw with grip nut
(8)
d.Tighten the
clutch screw (up /
down)
4) Insert the rear grid (19) onto the motor shaft (20), so that the
handle is at the top (like in the figure to the side), securing it using
the 4 screws provided (18.)
5) Insert fan (16) onto the motor shaft (20) and attach it so that the
screw (17) touches the milling formed on the motor shaft (like in
the figure), (at the end of the work, check that the fan is correctly
secured).
5) Couple the front grid (15) with the rear grid (19) and lock with the retention hooks. For
safety reasons, you must ensure the fastening with the appropriate locking screw (14) in
the holes provided on the edge of the grid, (the screw holes must be in the lower part).
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed by turning the switch (7) to one of the following
positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (13) located on the motor
body. To stop the motion and keep the ventilator still, press the button.