manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
9 / 20
Assembly page 9/16
Fax [phone]
3) Fasten the rear grid (6) to the motor casing, positioning the
corresponding pins and holes, and lock using the appropriate ring
nut (14).
4) Insert the fan (5) on the motor shaft (1) and lock with the
appropriate ring nut (14) turning it tightly anti-clockwise.
Couple the front grid (12) to the rear grid (6), blocking the front grid
by pressing with the back to fasten the hooks correctly (located on
the ring perimeter plastic front grille) and secure it in place with the
locking clip (15, must be at the lower part), and secure it in case of
presence of the screw with nut. Having done this, check that the
protection grid is firmly coupled and fastened to the motor.
Fasten the fan to the upright, inserting the lower hole on the adjustable
rod of the upright. Make sure that the fastening holes correspond: the
passage is close to the plug provideds, the nut screw (for fastening) is
more or less at the top of the rod. Lock the special metric screw (11)
in the holes describe and tighten normally. Cover the hole with the
plug provided.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Insert the plug of the fan in the power supply.
To start the fan turn the knob in clockwise for selecting the desired
speed, at the minium position the fan is silent, ideal for nightlife
settings with low power consumption.
To turn off, turn the knob in anti-clockwise to position min and
then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (2) located on the motor body.
To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired.
When not in use for long periods, the plug must always be removed from the socket.