User's Manual

Help 31
Press the following keys on your another phone to perform
the following functions, after entering your remote access
mode.
3.21.10 Setting the security code
This is used to change the remote access PIN if necessary.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
ANSWER MACHINE .
2. Press MENU and then VOL+ or REDIAL/VOL- to select
SECURITY CODE .
3. Press MENU and then enter the 4-digit security code.
4. Press MENU to save.
4. Help
The icon is not scrolling when the handset is
placed on the base
• Incomplete battery contact - adjust the handset on the
base unit.
• Dirty contact - clean the battery contact by wiping with an
alcohol moistened cloth.
• Battery is full - charging is not necessary at this time.
No dial tone
• If there is no base power, check the connections. Reset
the phone by unplugging then plugging it back into an
electrical outlet.
• If the handset batteries are empty, recharge the battery
pack for at least 24 hours.
• Move the handset closer to the base.
• Be sure to use only the provided telephone cords.
Poor audio quality
• If the base is too close to electrical appliances, reinforced
concrete walls, or metal door frames, move the base
from these areas.
Press... To...
1 Repeat the message
2 Play/Stop the current message playback
3 Skip forward to the next message
4 Toggle Answer Off/Announce Only/Announce
and Record modes
7 Listen to the Main Menu (for full voice prompts
only)
0 Delete the message