User's Manual

12 USING YOUR BABY MONITOR
3.4.1 Adjust talk back volume
The baby unit has 5 volume levels from Level 1 to Level 5.
During Talk Back, press
> or < on the baby unit to
increase or decrease the volume respectively.
NOTE
If lullaby is playing before talkback starts, the lullaby
playback will be paused. After finished talking back, it will
play the lullaby from the beginning again.
3.5 Temperature
The baby unit constantly monitors the temperature in your
baby's room. The temperature is displayed clearly on the
parent unit in idle screen. However, it is just for reference
only. There may be slight tolerance of the degree accuracy
comparing with the actual temperature. Therefore, please
pay more attention on the actual temperature in your
baby's room.
When the temperature detected is lower than 14ºC (or
57ºF), screen of parent unit will show the alert message
"Too cold!", or when higher than 39ºC (or 102ºF), will show
"Too hot!". Please check your baby immediately when such
alert message is triggered.
3.6 Lullaby
There are 3 lullabies available for playing to smooth your
baby.
1. Press
2 on the baby unit key to select the lullaby
and start playing.
2. During playback, press
2 to toggle between different
lullabies.
OR
Press
8 on the baby unit to start playing the selected
lullaby. Press
9 to stop playing.
3.7 Video on/off and video transfer
Up to two parent units can be used concurrently on the
same baby unit. However, only one parent unit can monitor
the video at one time. You can switch the video feed
between these two parent units.
The first powered up parent unit will connect to the baby
unit automatically, and the parent unit powered up later will
show
ANOTHER PU IS VIDEO MONITORING! for around 30 seconds,
and then the screen will be blank. Further press
6 will turn
off the screen.
If there is only one parent unit connected to the baby unit,
press
6 to turn on/off the video monitoring.