User's Manual

Doc Title : User’s Guide Revision : 1.0
Model :
Motorola M80×C
Page(s) : 27 of 32
This document contains confidential and proprietary information of VTech Telecommunications Ltd
To remotely access your answering system from external line, you need to key in 4-digit security code at the
external terminal (default code is 0000).
After entering the remote access mode, press the following keys to carry out your desired function.
4.20.10 Setting the security code
This is used to change the remote access PIN if necessary.
1. Press <MENU> and then <VOL+> or <REDIAL/VOL-> to select ANSWER MACHINE.
2. Press <MENU> and then <VOL+> or <REDIAL/VOL-> to select SECURITY CODE.
3. Press <MENU> and then enter the 4-digit security code.
4. Press <MENU> to save the setting.
5 HELP
The <Battery> icon is not scrolling when the cordless handset is placed on the charger
․Handset not properly seated on the charger –readjust the handset on the charger.
․Dirty contact – clean the charge contacts by wiping with an alcohol moistened cloth.
․Battery is full –charging is not necessary at this time.
No dial tone
․If there is no base power, check the connections. Reset the phone by unplugging then plugging it back into an
electrical outlet.
․If the cordless handset batteries are empty, recharge the battery pack for at least 24 hours.
․Move the cordless handset closer to the corded base.
․Be sure to use only the provided telephone cords.
Poor audio quality
․If the corded base is too close to electrical appliances, reinforced concrete walls, or metal door frames, move
the corded base from these areas.
No ring tone
․The ringer may be off.
․The volume may need to be increased.
Caller ID does not work
․Check your subscription with your network operator.
․If you subscribe to high-speed internet service (Digital Subscriber Line – DSL) through your telephone lines, you
must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL service provider for more
information about DSL filters.
A phonebook entry cannot be stored
․The phonebook is full. Delete an entry to free memory.
Press… To…
1
Press once to repeat the current message from the beginning.
Press twice to play the previous message.
2
Play/Stop the current message playback.
3
Skip forward to the next message
4
Toggle Answer Off/Announce Only/Announce and Record modes
5
Delete the message
7
Listen to the Main Menu (for Full Voice prompts only)