User's Manual

Help
This erases all data from the device's memory, and sets
it back to original factory settings. Make sure you have
backed up any important application-specific data to the
SD card. It does not erase data stored in the SD card,
1. Press
H and tap Settings > Privacy > Factory data
reset.
2. Tap Reset device.
• The parent unit will power down automatically
3. The parent unit will automatically power up again and
launch Baby Monitor Setup Wizard to help you
rent unit. See
How to get optimum connectivity and reception
between the parent unit and camera.
• If possible, position your wireless router in a central
location and closer to the parent unit and the camera.
The video screen hangs.
• Press B on the parent unit to exit the screen and
then select the camera again.
• Switch the camera on/off and connect again.
There is no response from the LCD touch panel
and parent unit keys.
• Press and hold L to turn off the parent unit.
• Remove the parent unit battery and install again.
The parent unit cannot find the camera unit.
• Check if the camera has been turned on and wait for
about 45 seconds.
• Check if the camera is ready for connection (LED is
blinking). If not, follow instructions on “Procedure for
resetting the Camera:”
I cannot create a new account in the server.
• Check if you have entered a valid email address for
the server to send you an email with the Activation
Key.
during the reset.
"Baby Monitor Setup”.
configure the basic settings on your pa
unless the "Erase SD card" box is ticked.
37
21.2 Factory Data Reset
22. Help