Instruction manual

22 English
Setting up the Basic Menu Using Network Operations
(User level: ID3)
The DVR operating condition is usually set through the DVR.
However, the following basic operation menu allows you to set the
DVR using the computer.
b Initial setting
A CLOCK SET (Refer to P24)
Setting the DVR’s clock
B DAYLIGHT SAVING/EXT. CLOCK SET (Refer to P24)
To set the automatic daylight saving change and the
automatic setting of the connected DVR clock.
C HOLIDAY SET (Refer to P24)
To set dates that will be considered as holidays.
b Recording settings
A RECORDING AREA SET (Refer to P25)
To display the proportion of each recording area and set the
recording resume operation when recording was stopped
due to the recording exceeding the area capacity.
B RECORDING CONDITIONS SET (Refer to P26)
To choose overwriting and other hard disk related condition
settings.
C NORMAL REC MODE SET (Refer to P27)
Normal and timer-controlled recording condition settings.
D PROGRAM REC SET (Refer to P28)
To program the individual or the combined recording rate of
the recording cameras
E TIMER SET (Refer to P28)
Timer-controlled recording condition settings.
F ALARM REC MODE SET (Refer to P30)
Alarm recording and pre-alarm recording condition settings
b General settings
A DISPLAY SET (Refer to P32)
To set the information display for the connected monitors.
B BUZZER SET (Refer to P32)
Warning buzzer settings
C HDD SET (Refer to P33)
To set HDD information display and specify the playback
disk when 2 HDD units are connected.
D NETWORK SET (Refer to P34)
To set the network connection conditions and the
connection password.
E RS-485 SET (Refer to P34)
DVR interface information display when operating the
system controller
b Screen settings and DVR information
A MASK SET (Refer to P35)
Mask settings for specific channels
B POWER LOSS/USED TIME (Refer to P35)
Power loss history, operating time, firmware version, etc.
information display
C INITIALIZATION LOG (Refer to P35)
Hard disk initialization history information display
Basic Settings Menu Outline
The setting menus outside the ones above are outside the scope of network operations. Therefore, use the DVR to set
any other settings.